Allen Gwynnes Solid Handling Pump - AGP/AGL Series

Product Description:
Spare parts stocking is cut to minimum through high interchangeability of manufactured components. The standard casing mounted arrangement feature "BACK PULL-OUT", the end shaft diameter are design to fit the tapper lock pully. An alternative bearing bracket mounted arrangement can be supplied to suit various discharge position.

Product Specification:
Casing
High efficiency volute with self-venting vertical centre line discharge. The impeller and casing is equal at all the point. This kind of design is help to reduce turbulence, cavitation. This design can benefit casing life is greatly extended.

Impeller
Semi-open impeller is a compromise between an open and enclosed impeller. It incorporates a single shroud, usually located on the back of the impeller. Semi-open impeller operates more efficiently than an enclosed impeller because of lower disc friction and tighter axial clearances. This impeller is suitable for handling solid application.

Shaft
Large diameter shaft design to make full load stresses with minimum deflation. Fany machined and ground section where fine finishing and dimensional tolerance are critical. The shaft end design is benefit for tapper lock pully

Bearing
Two identical bearings sized for long running life under maximum load operation. Grease lubrication is standard.

Bearing Housing
Sturdy design to ensure rigidity and vibration-free operation.

Document:
Product Leaflets:
https://pumpmax.com.my/wp-content/uploads/pdf/Allen Gwynnes End Suction Pumps.pdf